The last time i rode my bike the clutch slipped. Annoying.

I tore the clutch down today and measured everything and the parts were hardly wore.

I had to replace my clutch cable also so i took off the sprocket cover and lo and behold the worm gear was barley hanging on by one bolt. Cleaned up every thing and installed the clutch cable on that end.

I went to connect the cable on the handle bars and the cable was six inches too long.

So i have the clutch cable going to the opposite side of the headlight and coming back across.

Works good and no slip.

I hope i'm ready to ride. Roy

That's way better than it being 6 inches too short.